3dlabs Oxygen VX1 User Manual download pdf (Page 12)

Installing Hardware

3 3Dlabs Oxygen VX1/GVX1 User’s Guide

Installing Hardware

Oxygen GVX1 and Oxygen VX1 cards are available in PCI and AGP versions. Check the

documentation for your system for the location of PCI and AGP expansion slots in your

system.

✏

To remove an old card from your system

Make sure you have uninstalled any old drivers and installed the Oxygen driver in

their place.

Turn off and unplug the power source for your system and each of

its peripherals.

Unplug the monitor cable from the old card.

Remove the cover from your system.

Attach the anti-static strap to your wrist, and attach the other end to a bare,

conductive (as opposed to painted or sticker-covered) area of your system’s chassis.

Remove any screws securing the card to the chassis.

Lift the card out of the slot.

✏

To install your Oxygen card

Turn off and unplug the power source for your system and each of its peripherals, if

you have not already done so.

Remove the cover from your system so you can access an appropriate expansion slot.

See your system documentation for AGP and PCI slot locations.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 51 52

No comments

3dlabs Oxygen VX1 User Manual Page 12